本帖最后由 cfplzjc 于 2021-12-27 10:21 编辑
1、网络拓扑,积分不够发不了图。
2、关键配置
<DeviceA> system-view [DeviceA] irf topo-domain 10
The configuration will take effect at the next startup. [DeviceA] irf-port [DeviceA-irf-port] port group interface gigabitethernet 1/0 [DeviceA-irf-port] quit
[DeviceA] chassis convert mode irf,注意重启A后,马上重启B,要不然容易堆叠失败。 The device will reboot to operate in IRF mode. You are recommended to save the running configuration to the next-startup configuration file. Continue? [Y/N]:y
flash:/startup.cfg exists, overwrite? [Y/N]:y
Do you want to convert the content of the next-startup configuration file flash:/startup.cfg to make it available in IRF mode? [Y/N]:y
The configuration file is converted successfully. ----------------------------------------------------------------------- <DeviceB> system-view [DeviceB] irf member 2 [DeviceB] irf topo-domain 10
[DeviceB] irf-port [DeviceB-irf-port] port group interface gigabitethernet 1/0
[DeviceB] chassis convert mode irf The device will reboot to operate in IRF mode. You are recommended to save the running configuration to the next-startup configuration file. Continue? [Y/N]:y
flash:/startup.cfg exists, overwrite? [Y/N]:y
Do you want to convert the content of the next-startup configuration file flash:/startup.cfg to make it available in IRF mode? [Y/N]:y
The configuration file is converted successfully. 3、实验结果。
4、优化,增加堆叠分裂探测。交换机简单配置下
<DeviceA> system-view [DeviceA] irf domain 10
[DeviceA] interface reth 1 [DeviceA-Reth1] member interface gigabitethernet 1/2/0 priority 100 [DeviceA-Reth1] member interface gigabitethernet 2/2/0 priority 80 [DeviceA] interface reth 1 [DeviceA-Reth1] mad arp enable |